How to configure Cisco AP via console

How to configure Cisco AP

Prerequisite:
9600 baud, 8 data bits, None parity, 1 stop bit & no flow control

ap>en
ap>conf t
ap(config)# line vty 0 4
ap(config-line)# login local
ap(config-line)# exit
ap(config)# line console 0
ap(config-line)# login local
ap(config-line)# exit
ap(config)# username admin privilege 15 password password
ap(config)# hostname TestAP

TestAP(config)# dot11 ssid test
TestAP(config-ssid)# auth open
TestAP(config-ssid)# auth key wpa ver 2
TestAP(config-ssid)# wpa-psk ascii 12345678
TestAP(config-ssid)# guest-mode
TestAP(config-ssid)# exit

TestAP(config)# int d0
TestAP(config-if)# encryption mode ciphers aes
TestAP(config-if)# ssid test
TestAP(config-if)# channel 1
TestAP(config-if)# no shut
TestAP(config-if)# exit

TestAP(config)# int bv1
TestAP(config-if)# ip address 192.168.1.10 255.255.255.0
TestAP(config-if)# desc "LAN interface"
TestAP(config-if)# exit
TestAP(config)# default-gateway 192.168.1.1
TestAP(config)# exit
TestAP# wr mem

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Scroll to top